How to use
Extralube ZX1 Micro Oil Treatment
The concentrate is added in a 5% ratio to existing engine, hydraulic, gear or machine oil (e.g. 50ml per 1 litre. For a more detailed breakdown of the ratios, please see the table below).
Its strong intermolecular reaction with metals rapidly causes carbons, dirt and other contaminants to separate from surfaces. An initial measure can therefore be applied about halfway between oil changes so that debris is removed from the system when oil and filter are subsequently replaced.
For best results, warm the engine or machinery to operating temperature, then add the appropriate amount. Run the engine/machine again for at least 5 minutes to allow circulation of the treatment throughout the engine/machine. Then shut down and allow to cool. The ZX1 Extralube should have fully bonded, and the treatment will now be in full effect.
Use as a Machining Fluid
According to the severity of the operation, Extralube ZX1 can be applied neat or in dilutions down to 10% in soluble cutting oils and water, and between 5% and 20% in emulsions, paste and compounds for drawing and pressing metals. Spray or paint on to metals for releasing, drying out and protection.
It can be thermally bonded onto tools and load bearing surfaces by heat pretreatment at temperatures in the region of 60°C.
Use C60 Spray Lube
To disperse damp, release seized mechanisms, protect stored metals, and as a general impregnating lubricant, it has been designed to be used in any environment from around the home to hostile offshore situations in extreme ranges of temperature. Universal liquid engineering.
THERE ARE FOUR UNIQUE PRODUCTS IN OUR RANGE
The Flagship EXTRALUBE ZX1 Micro Oil Metal Treatment - available in 5 sizes 100ml, 250ml, 500ml, 1 litre and 4 litre (available upon request) designed to protect and prolong the life of metal surfaces, smoothing and lubricating, reducing friction, therefore saving energy and fuel and reducing harmful emissions.
C60 Spray Lube supplied in an environmentally friendly 300ml pump applicator " The Engineers Friend" not just a spray lube but an all purpose industrial strength lubricant which as tremendous penetrating and lubricating properties.
C76 35ml handy nozzle applicator - designed for precise application with no waste ideal for lubricating Sewing and Knitting Machines.
Super Grease - a High Temperature Lithium Complex based grease reinforced with ZX1 Micro Oil Metal Treatment
At normal working temperature the EXTRALUBE ZX1 Micro Oil Metal Treatment cleans and treats your engine/equipment by thermally bonding to the wearing surfaces without compromising any design tolerances. A 15 -20 minutes drive completes this simple treatment resulting in less friction, protected components along with increased mpg and reduced emissions.
